|
|
Post by poet on Mar 27, 2019 17:21:49 GMT -7
I did this back in 2017. Its the Maz/Pittman Austin from Altered States. The top is so low there's just no way to get a good interior pic.
|
|
|
|
Post by RetroSpectKustoms on Mar 27, 2019 19:06:10 GMT -7
What a cool Gasser!! That chop is radical. I really dig the gold engine detailing.
|
|
|
|
Post by sharp on Mar 27, 2019 19:06:56 GMT -7
That's awesome Dennis!! Is the body resin?
|
|
|
|
Post by poet on Mar 27, 2019 20:03:04 GMT -7
Thanks guys.
Yes Sharp, the body is resin from Altered States. They do very good work.
I'd like to build another but rework the chassis so it sits lower in the back.
|
|
|
|
Post by DeeCee on Mar 28, 2019 0:38:19 GMT -7
That is seriously cool for an Austin mate.
|
|
|
|
Post by stitchdup on Mar 28, 2019 2:06:27 GMT -7
Cool, i think there are more of the 1/1 austins in the us now than there are in the uk
|
|
|
|
Post by leon on Mar 28, 2019 2:19:15 GMT -7
That is awesome looking!
|
|
|
|
Post by poet on Mar 28, 2019 5:40:45 GMT -7
Thanks guys.
|
|
|
|
Post by sharp on Mar 28, 2019 10:22:25 GMT -7
Thanks guys. Yes Sharp, the body is resin from Altered States. They do very good work. I'd like to build another but rework the chassis so it sits lower in the back. Thanks Dennis,I'm gonna check those guys out! |
|
|
|
Post by mustang1989 on Mar 28, 2019 14:07:09 GMT -7
Very cool build Dennis. Nice paint too.
|
|
|
|
Post by poet on Mar 28, 2019 16:29:09 GMT -7
Very cool build Dennis. Nice paint too. Thanks Joe. |
|
|
|
Post by dumpydan on Apr 1, 2019 3:55:52 GMT -7
Looks real good, would be a blast to drive.
|
|
|
|
Post by poet on Apr 1, 2019 5:06:56 GMT -7
Looks real good, would be a blast to drive. Thanks Dan!! |
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Apr 7, 2019 9:20:21 GMT -7
Where did you get the injector stacks?
|
|
|
|
Post by poet on Apr 8, 2019 10:48:09 GMT -7
Where did you get the injector stacks? I got them at Ted's Modeling Marketplace. Its their Injector Velocity Stacks #2. They are 15mm tall. However I see that they are out of stock. If you really need them and can't wait for him to restock perhaps we can make a trade, as I have another set. You could also fabricate some from aluminum tubing. I did these on my Olds gasser. They looked better before I tried to squish them together when I should have ground them flat on one side. They can be made to shine after you peen the ends over using a scouring pad. I used a punch to make the flare by just setting it on the basement floor and lightly tapping with a hammer.
|
|
